With monitor mode working, the last test for the card was packet injection. (mac80211 monitor mode already enabled for wlan0 on 6) If airodump-ng, aireplay-ng or airtun-ng stops working afterĪ short period of time, you may want to run 'airmon-ng check kill' : ~# airmon-ng start wlan0 6įound 2 processes that could cause trouble. Please run "iw wlan0 del" before attempting to continue You already have a wlan0 device but it is NOT in station mode. Phy7 wlan0 8812au Realtek Semiconductor Corp. Wlan0 IEEE 802.11 Mode:Monitor Frequency:2.412 GHz Tx-Power=12 dBmįinally, I used airmon-ng to verify that I could also enter monitor mode using it. Next, I manually put the card in monitor mode to make sure that it could properly switch. Retry short limit:7 RTS thr:off Fragment thr:off
Mode:Managed Access Point: Not-Associated Tx-Power=12 dBm
#How to install lsusb in aircrack drivers
With the drivers installed, I reconnected the device and verified that it showed up in iwconfig. : ~# apt-get install -y realtek-rtl88xxau-dkms : ~# apt-get purge realtek-rtl88xxau-dkmsįinally, I (re)installed the proper Realtek drivers. : ~# apt-get remove realtek-rtl88xxau-dkms NOTE: do not think that you can skip this step, or you will probably run into issues later on. Next, I made sure to remove and purge the existing drivers from my system. Verifying Kernel and Installing the Driversįirst, I made sure that my kernel was up-to-date.
There are a few threads with conflicting results or solutions though. While the Alfa AWUS036ACH (pictured below) doesn’t work out of the box, support was recently added in the Kali rolling release. I recently picked up a 5GHz/AC Alfa card for engagements, so I wanted to cover AWUS036ACH setup in Kali.
0 kommentar(er)
